Firmware Download Samsung Galaxy Core LTE Prime SM-G360M

Romphe || Samsung Galaxy Core LTE SM-G360M Prime with the firmware that is used to flashing then your smartphone can be in use again if you just damage the software only then from here you can follow the existing tutorial to Upgrade or Install Samsung Galaxy Core LTE Prime SM -G360M to System Version: KitKat 4.4.4. 

Firmware is available for download You can download the firmware below before that we have to look at the smartphone and measure against the type, because if it is not suitable then it will add severe or can not be repaired again using flashing if you are careful and do flashing well then your smartphone can live like a face.

Usually a case that happens on a smartphone like firmware that flash does not match the type or file corrupt then it will cause flashing to be gagl and unsuccessful for more details can follow the tutorial below for beginners success.

Firmware Download Samsung Galaxy Core LTE Prime SM-G360M

NOTE !!! : I am not responsible if there is damage at the time of flashing then of that please be careful for his attention thanks.

Firmware Download Samsung Galaxy Core LTE Prime SM-G360M

Flash Tools

USB Driver
Odin Samsung

Steps Flash

#1. Things that should not be forgotten is extract all the files that have been downloaded because it is still in the form of zip to live extract all is wrong because already in extract easy to run the application.

#2. Open Odin and install Samsung Driver on your PC until finished if it can restart your computer.

#3. Live step Next turn off the Samsung Galaxy Core LTE Prime SM-G360M and turn it back on by pressing the volume down key + home + power simultaneously and wait for it to vibrate into download mode and press the volume up button then it goes into download mode.

#4. Connect your Samsung Galaxy Core LTE Prime SM-G360M to your PC using the USB cable so it automatically detected ID: COM on Odin turns on the phone and your PC is connected with Odin.

#5. Lost click PDA / AP on Odin and navigate the file of your firmware extract result that is formatted xxx.tar.md5 where you put it there you can enter on odin wait until the loading process is complete.

#6. Live directly click START and wait until the process is complete until there is a reading PASS.

Iklan Atas Artikel

Iklan Tengah Artikel 1

Iklan Tengah Artikel 2

Iklan Bawah Artikel